Quickrep SP1000 One component special repair

DIRECTION FOR USE

Surfaces should be clean sound and free from oil, grease, laitance and loose particles. Metal surfaces should also be clean and free of rust, oil, grease and contaminants. Remove damaged concrete and prepare exposed steel reinforcement. Thoroughly clean repair area using high pressure water jet to remove all loose debris and contamination. The concrete should be pre-saturated with water before application. This is essential for the proper adhesion of the mortar to the sub-surface.

Deep cracks with a depth greater than 2 mm should be opened in (V) shape and then repaired with quickrep sp1000.

Mixing:

First, pour water into the appropriate container. The quantity of water depends on the desired consistency. Then add the powder slowly.

Mixing ratio: powder (4), water (1)

Mix with a paddle mixer or trowel For 3 to 5 minutes to ensure a homogenous lump free material is achieved. Do not try to remix the product after losing workability by the addition of more water.

Replace damaged concrete using quickrep sp1000, build up in layers if necessary. Apply quickrep sp1000 with a trowel or spatula. Press hard by hand. Thicker repairs may be achieved by working in layers.

Curing:

Keep repaired areas damp, with spraying water at least 24 hours.

In tropical areas use a curing compound or Nylon on the surface.